How to Do Rolled Roofing For Your Home

When installing rolled roofing, the first step is to prepare your roof deck. Apply roofing cement and then push nails at every 3 inches along the required edges. Roll roofing has a long lifespan, but it requires some patience. Read on to learn how to do rolled roofing for your home. You’ll be glad you did once you know the basics. Roofing is an essential part of any home, so follow these tips to ensure your roofing will last for years to come. roofing supply store

First, measure your roof. Make sure you have an accurate measurement so you don’t cut a piece that is too long or too short. You may want to enlist a friend or family member to help you measure. If your roof is rectangular or square, measuring will be a lot easier. Measure the width and length of the roof, then multiply them to determine the length of the rolls. This step will ensure you have the right amount of roll roofing.

Roll roofing can be installed over existing shingles. It is better to remove the shingles before installing roll roofing, but you can do it over existing shingles, if you prefer. Before installing roll roofing, you should ensure that the area is clean of debris or other materials. Debris can puncture the metal roofing system. However, rolled roofing is often cheaper than shingles and is not recommended for residential homes. Rather, it is a common option for gazebos, garages, and sheds.

Roll roofing can be installed on roofs with irregular shapes or sloping surfaces. Measure the width of your roof using a tape measure. If the roof is uneven, repeat the measurement process for each section and add up the overlaps and overhangs. To save time, you may want to hire a roof assessment expert to help you with these measurements. Once you have a precise measurement, you can purchase the rolled roofing you need.

First, you should mark the end of the first row with a chalk line. Next, you should apply roofing cement along the edges of the rolled roofing. To ensure the roofing cement dries evenly, wear gloves while working with roofing cement. Spread the cement one-fourth of an inch thick. Then, you’ll need to attach the first layer of roll roofing. Make sure to work below the chalk line to avoid damaging the rolled roofing.

There are pros and cons to roll roofing. Unlike asphalt shingles, roll roofing requires no nails. You apply lap cement on the bottom edge to prevent it from lifting in a storm. Then, you lay a layer of asphalt over the top. Roll roofing works well on low-inclined roofs, including those found on gazebos, sheds, and three-season rooms. The good news about roll roofing is that it doesn’t require special machinery and is easy to install. Make sure to work in 50-degree temperatures or above.

Roll roofing is easy to install, but the best way to ensure the quality of the job is high. If you don’t have enough experience in the trade, you can hire a professional to perform the job for you. Remember to get all of your materials and tools before starting the installation. Failure to have them can halt the process. All of these materials and tools are readily available at home improvement stores. Just be sure you have everything you need and follow instructions carefully.