How to Install Closure Strips on Metal Roofing
If you are looking for a way to secure the seams and fasteners in metal roofing panels, you’ll need to know how to install closure strips on metal roofing. Closure strips can be fabricated several different ways and are a vital part of your metal roof installation. Some closure strips are interlocking, which allows them to function properly without causing damage. To install closure strips, follow the instructions of the manufacturer of your metal roofing material. commercial roofing
Place the closure strip over the panels evenly, allowing it to fit over them tightly. Use chalk to mark where to install the closure strip. Use a sealant tape to run the length of the ridge and up from the line of snapping. Place the first piece of closure strip on top, and then position the next one six inches above it. You may need to trim it a bit to fit the ridge properly.
Now, install the closure strips to the metal roofing panels. The eave closure strip has pyramid-like protrusions on its ends that are inserted into the bottom of each ridge. The ridge closure strip is similar to the one used on the eave, but there are some differences. A vented closure strip will act as a ridge vent, while a solid closure strip will not be necessary if the roof does not have a ridge vent.
To install closure strips on metal roofing, you must first prepare your roofing materials. You’ll need a stepladder or extension ladder. Your ladder must extend at least three feet above the edge of the roof. Measure the distance across the lower edge of your roof, and have someone else help you. Then, buy closure strips based on the measurements you’ve taken. Remember to include a tube of butyl caulking every 20 feet.
A good closure strip will not only increase the performance of your metal roof, but it will also improve the quality of the roof and keep noise and pests out. These strips are a relatively inexpensive requirement for metal roofing installation. They’re easy to ship and come in boxes of 100 strips, which will cover around 300 square feet of roof. Then, it’s time to install the closure strips. So, get your roof ready for winter!
After installing the closure strips, you need to apply a waterproof roof caulk along the 6-inch-wide horizontal end lap seam. Ensure that every screw head is properly sealed, and then proceed to install the metal roofing panel. Once the caulk is dry, it’s time to apply sealant and waterproof membrane. Closer strips are essential for metal roofs because they form a tight seal against pests and insects. Also, they make the roof sound and moisture-proof.
Besides the closure strips, you’ll need to purchase the metal roof panels, as well as the appropriate trim. The most basic trim for a metal roof panel is the eave, rake, and ridge cap. The metal flashing comes in various colors and styles and you can order custom ones for your specific application. Additionally, you can purchase self-taping hex headed screws, butyl tape, and pipe boots from your metal roofing supplier.