How to Install EPDM Roofing

If you’re wondering how to install EPDM roofing, read this article. This step-by-step guide will show you how to install this roof type. The main reason to avoid seams is because they cause leaks and moisture damage. However, many projects only require a single seamless layer. You can install EPDM roofing yourself if the project is small, like a residential roof. However, larger commercial roofs will require professional installation. When installing EPDM roofing, it’s important to give the roof a rest period. roofing repair

When you’re installing EPDM rubber roofing, you’ll need to place the strips over flashings where the roof meets a brickwork wall. These strips are often plastic-coated metal. You can also use metal gutter drip trim – a universal piece that chases into the mortar between the brickwork. EPDM roofing requires relatively little maintenance in the long run, but you should still have it checked regularly for leaks or damage.

After you’ve installed EPDM roofing, you’ll need to mark the edges. Use a pencil or chalk to make sure you’ve marked each section with a thick overhang. This will help you avoid wrinkles later. Next, make sure you’ve laid enough membrane over the roof area to cover the roof surface. Once this is complete, you can start gluing the sheets to the roof. Then, you’ll need to cut and install the drip batten and drip back trim.

If you’re unsure about EPDM roofing, hire a professional. Even if you know the basics, there are many common problems that can arise. The most common problem is shrinkage. If the EPDM was not relaxed enough prior to installation, the seams could not adhere properly to the roof. If this happens, call a professional roofing company for advice. They will recommend the best way to repair the problem.

Apply bonded adhesive to the surface of the membrane. Wait for five to 20 minutes to let it dry before you proceed to the next step: installing the membrane. Once it’s dry, you’ll need to brush it to make sure it’s completely adhered to the roof surface. The adhesive will also strengthen the connection between the membrane and the roof surface. After the adhesive has dried, you’ll need to apply a final coat to the entire roof.

Once the adhesive has dried, apply the EPDM rubber sheet. The rubber sheet should be evenly spread on the surface without wrinkles or dips. Be sure to smooth the membrane with a broom to prevent any wrinkles. The adhesive should be applied evenly, in sections. Use a silicone roller to press the membrane into place. If the EPDM rubber sheet is unevenly textured or wrinkled, you may need to repeat the process until it looks smooth.

EPDM roofing installation requires some basic steps. Clean the roof surface thoroughly. Remove any debris or loose dirt. Then, apply a rubber roof cleaner. You can also apply a small amount of rubber roof cleaner to small areas of the roof. Apply the cleaner in circular motions and use a soft brush. Rinse well to remove any leftover dirty residue. If you’re using a spray cleaner, be sure to rinse it thoroughly afterward to avoid any unpleasant surprises.