How to Install Metal Roofing Valleys

When installing metal roofing, there are several factors you should consider. Choosing the right valley system depends on the size, design, and shape of the panels. Some contractors fit the panels into a “C” or “J” channel, leaving large gaps where the panels enter the receiving channel. These gaps tend to fill with debris over time, depending on the type of metal roofing and the proximity to trees. If a channel becomes clogged, water will accumulate inside, running underneath the metal roofing. roofing shoes

To cut the flaps, first measure the distance between the eave and the top of the valley. Divide this distance by two. If the valley is wider than the eave, then cut a piece of metal roofing at an angle of 45 degrees. Afterward, use a hammer to tap the flaps into place at a 90-degree angle. Next, apply silicone sealant one inch from the edge of the eave trim. Use 10# x 1″ pancake screws to secure the flaps.

When installing metal roofing on a valley, remember that the valley area may have special concerns, so it is a good idea to hire a professional. Valley flashing creates an impermeable seal, but debris can cause damage to it over time. If you notice rust stains on the ceiling in the metal valley, it means the metal valley has rusted through. Then, make sure you install the valley flashing properly to ensure that your new roof looks beautiful.

When installing a valley detail on your metal roof, you should be careful to follow the manufacturer’s installation instructions. A good example of this is installing two valley pieces at the ridge, then installing the panels around the valley and tying in the ridge cap. Follow the manufacturer’s installation instructions and the details provided by WTW. In any case, you’ll be installing the correct metal roofing for your roof.

Once you have the valley flashing installed correctly, you should install the underlayment before installing the shingles. You can paint the flashing to match the shingles or leave the steel or copper face unaltered. These steps may seem complex and time-consuming, but they’ll make a dramatic difference in your roof’s appearance. When installing your metal roofing, you should remember to carefully place the first piece of flashing in the valley, ensuring that it is centered in the roof valley. If the flashing doesn’t line up, it could cause leaks and damage.

You can also try installing the metal roofing valleys in a curved roof. Many structures have multiple additions, and the roof faces may meet in the middle. When installing the valleys, remember to use a screw in each bottom corner. It’s similar to installing metal roofing panels on the ridge and overlapping the first panel by 4 inches. Afterwards, you can place the final panel and trim it to fit.